Machine Tool Genome Project
  • Home
  • RCSA
    • MTGP Registry
    • Request for Artifact Test
    • Request for Best Speed
    • Chatter Analysis
  • Training

Tap-Testing

10/9/2018

0 Comments

 
This what a tap-test looks like. Ideally, if we are applying IIoT or Industry 4.0 to a milling tool, we would want to have a sensor mounted right at the cutting edge. Of course that's not possible...permanently. We can attach an accelerometer, temporally, and simulate the cutting forces with an instrumented hammer. Doesn't look too hard to do, does it? Doesn't take long, either. Results are often incredible.
0 Comments



Leave a Reply.

    About Us

    Sharing information about high performance milling technologies, the result of 30 years of research.

    Archives

    August 2019
    May 2019
    April 2019
    February 2019
    January 2019
    December 2018
    November 2018
    October 2018
    September 2018
    August 2018

    Categories

    All
    Chatter
    Dynamics
    Endmills
    Milling
    Shophacks
    Testing
    Toolholders

    RSS Feed

    View my profile on LinkedIn

Machine Tool Genome Project
Copyright © 2018-2020

DISCLAIMER
  • Home
  • RCSA
    • MTGP Registry
    • Request for Artifact Test
    • Request for Best Speed
    • Chatter Analysis
  • Training